The installation of step seal involves the following steps:
. Prepare for work. First, ensure that the piping system is clean and dust-free. Check the installation site of the step seal for damage or leakage, and replace the corresponding pipe fitting or seal if necessary.
Select and prepare the step seal. Prepare the correct step seal model and size, as well as the appropriate accessories. Use a specialized tool to cut the step seal to the desired length and ensure that both ends are cut at a 45 degree Angle for easy installation.
Install the step seal. Place the step seal over the pipe joint to be sealed and gently tamp it down with your hand. The joint is then tightened so that the step seal fits as tightly as possible at the pipe joint. Ensure that step seal and pipe fittings are properly connected and connected according to product specifications. Fill the Spaces between the fittings to ensure tightness.
.Check the sealing effect. After installation, a sealing test is performed to verify the sealing effect of step seal. If a leak is found, the pipe joint can be adjusted or tightened until it is completely sealed.
Take care to ensure that the instructions in the product manual are followed during installation and that lubricating oil is applied to the lips prior to installation to facilitate installation and prevent burns during initial operation. At the same time, avoid using hammer and other forced tools to install, so as not to damage the seal.