Fluorine rubber O-ring is often used in some equipment that needs to be sealed, compared with seals, it is light in weight and has a wide range of use, and the user needs to carefully handle the details in the process of the device. For normal use.
1, when using imported fluorine rubber O-ring, the operating quality of the device process directly determines whether the sealing state is stable, and also has a huge impact on the service life of the O-ring. In addition, the leakage problem in the later use is often caused by the imperfect operation of the device, which is simple to damage the O-ring product. Although the imported O-ring parts can be replaced during the operation of the equipment, if the damaged sealing parts are not replaced in time, great production loss will be formed, and even damage to the production equipment may be formed.
2, in the process of fluorine rubber O-type sealing ring device must pay attention to the treatment of all details, especially the scratches and damage conditions should be adjusted in time. It is not allowed to make mistakes in the operation of the device, although it has a high elasticity and deformation strength, but the fault device will still cause great damage to the sealing parts. Problems such as the sealing ring being scratched or the device being accidentally twisted are typical safety hazards. The sealing groove and cooperative surface must be completely cleaned before the device to remove all impurities. If there are cracks or scratches, the missing parts should be replaced in time. Grease is uniformly coated on the O-ring surface to ensure that the equipment is intact in operation.
3, in order to avoid the fluorine rubber O-ring is scratched by sharp objects during the operation of the device, then there is a certain introduction Angle in the shaft end of the device and the hole section, so as to insist that the sealing ring can be smoothly installed to the fixed position. If the device needs to pass a thread, it must use a special metal guide to operate, and pay more attention to insisting that the O-ring does not contact the sharp part when passing through the incision, as long as the condition is intact to ensure normal operation.
In the process of fluorine rubber O-type sealing ring device, deal with the details, which is not only for the sake of its sealing but also for the sake of allowing it to obtain a good use effect, when using, deal with the details according to the above method to eliminate defects.